McCulloch MC621 Owner's Manual download pdf (Page 13)

Adjusting the Control Cable

Checking the Control Cable

Release the control bar to remove the slack in the control

cable (Figure 20).

IMPORTANT: The control cable must contain some slack

when you disengage the control bar for the auger blades

to stop properly.

NOTE: You may need to adjust the control cable from

position 1 (default) to position 2 if you notice belt slip

when the control bar is engaged.

NOTE: If the control cable is adjusted to position 2,

ensure that the auger stops properly when the control bar

is released

Figure 22

1. Auger blades 2. Scraper bar

Adjusting the Control Cable

1. With the control bar disengaged, unhook and move

the control cable to the highest position. (Figure 21).

Figure 20

1. Control bar

2. Adjuster link

3. Cable positions

Figure 21

Position 1: Default position

(Lower Hole as shown in illustration)

Position 2

Inspecting the Auger Blades/

Scraper Bar

Before each session, inspect the auger blades for wear.

When an auger blade edge or the scraper bar has worn

down have an Authorized Service Dealer replace the

auger blades and the scraper bar (Figure 22).

NOTE: Auger blades and scraper bar are wear items and

may have to be replaced after extended use.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

No comments

McCulloch MC621 Owner's Manual Page 13