McCulloch B28 PS Operator's Manual download pdf (Page 15)

English--- 15

115432326 Rev. 4 2/17/12

STARTING AND STOPPING

W ARNING: Use of an incorrect

or damaged blade could result in

serious injury or death. Always

discard a blade that is bent,

twisted, cracked, broken or

damaged in any other way. Never

attempt to straighten a twisted

blade so that it can be reused. Only

use original blades of the specified

type.

Check before starting

S Check the blade to ensure that no cracks

have formed at the bottom of the teeth or

by the centre hole. Discard a blade if

cracks are found.

S Check that the trimmer head and trimmer

guard are not damaged or cracked.

Replace the trimmer head or trimmer

guard if they have been exposed to

impact or are cracked.

S Never use the machine without a guard

nor with a defective guard.

S All covers must be correctly fitted and un-

damaged before you start the machine.

Cold engine

Primer bulb: Press the primer bulb 10

times until fuel begins to fill the bulb. The

primer bulb need not be completely filled.

Chok e : Move the blue engine choke lever

over to the FULL CHOKE (closed) position.

Startin g

Hold the body of the machine on the

ground using your left hand (CAUTION!

Not with your foot!).

Firmly grip the starter rope handle with

your right hand. DO NOT squeeze

throttle trigger. Slowly pull out the cord

until you feel some resistance (the starter

pawls grip); then quickly and powerfully

pull the cord until engine attempts to start,

but no more than 3 times.

Never wrap the starter cord around

your hand.

Move the blue engine choke lever to the

HALF CHOKE (½) position. Repeat pulling

the cord until the engine starts and runs.

Then, move the blue engine choke lever to

the OFF CHOKE (opened) position.

W ARNING: The complete clutch,

clutch cover, and shaft must be

fitted before the machine is started,

otherwise parts could come loose

and cause personal injury .

Always move the machine away

from the refueling area before

starting. Place the machine on a

flat surface. Ensure the cutting at-

tachment cannot come into contact

with any object.

Make sure no unauthorized

persons are in the working area,

otherwise there is a risk of serious

personal injury . The safety

distance is 15 meters.

Starting and stopping

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Comments to this Manuals

No comments