McCulloch T26CS Operator's Manual download pdf (Page 15)

STARTING AND STOPPING

English – 15

• Move the choke lever to Half Choke position as soon

as the engine sounds as if it is trying to start.

• Pull starter cord while trigger is in the full throttle

position until engine starts.

• Once engine is started leave the choke lever in Half

choke position for 20 seconds. Then move the choke

lever to RUN position.

If engine does not start move the choke lever to Full

Choke position and do the steps again.

Always pull starter cord straight out. Pulling the starter at

an angle will cause cord to rub against the eyelet. This

friction will cause the cord to fray and wear more quickly.

Always hold the starter handle when cord retracts. Never

allow cord to snap back from extended position. This

could cause cord to snag or fray and also damage the

starter assembly.

Warm engine

• Set the choke control in the RUN position.

• Then grasp the starter handle with your right hand and

pull the starter cord.

Stopping

Stop the engine by switching off the ignition.

CAUTION! The stop switch automatically returns to the

start position. In order to prevent unintentional starting,

the spark plug cap must be removed from the spark plug

when assembling, checking and/or performing

maintenance.

WARNING! When the engine is started

with full throttle the cutting attachment

will start to rotate immediately.

S1156009-38,T26CS_1.fm Page 15 Tuesday, December 10, 2013 9:00 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

McCulloch T26CS Operator's Manual Page 15