545196757 Rev. 1 12/15/08 BRWINSTRUCTION MANUALIMPOR TANT INFORMATI ON: Please read these instructions carefully and makesure you understand them befo
10The carburetor has been carefully set at thefactory.Adjustments maybenecessary ifyounotice any of the following conditions:S Engine will not idle wh
11TROUBLE CAUSE REMEDYEngine will notstart.1. ON/OFF switch in OFFposition.2. Engine flooded.3. Fuel tank empty.4. Spark plug not firing.5. Fuel not r
12DECLARATION OF CONFORMITYEC Declaration of Conformity (Only applies to Europe)We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46--36--146000, a
13TECHNICAL DATA SHEETMODEL: TrimMac 250 LSENGINEDisplacement, cm325Maximum engine power, measured inaccordance with ISO 8893, kW 0,7Catalytic convert
2IDENTIFICATION (WHAT IS WHAT?)Assist HandleShieldTrimmerHeadShaftMufflerFuel MixFill CapStarter HandleON/OFF SwitchThrottle TriggerChoke LeverSpark P
3SAFETY RULESWARNING: When using gardeningappliances, basic safety precautions should al-ways be followed to reduce the risk of fire andserious injury
4S Stop engine and allow to cool before re-moving fuel cap.S Always store gasoline in a container ap-proved for flammable liquids.CUTTING SAFETYWARNIN
5ADJUSTING THE HANDLEWARNING: When adjusting the assisthandle,besureitremains above the safety labeland below the mark or arrow on the shaft.1. Loosen
6STAR TIN G A COLD ENGINE (or awarm engine after running out offuel)1. Set unit on a flat surface.2. Move ON/OFF switch to the ON position.3. Slowly p
7WARNING: Use only 2 mm diameterline.Othersizesandshapesof linewillnotad-vanceproperly andwill result in improper cut-tingheadfunctionor cancauseserio
8INSPECT AND CLEAN UNIT ANDLABELSS After each use, inspect complete unit forlooseordamagedparts. Cleantheunitandlabels using a damp cloth with a mildd
95. When installing new line on an existingspool, hold the spool as shown.6. Bend the line at the midpoint and insertthe bend into the slot in the cen
Comments to this Manuals