McCulloch CS 360T Instruction Manual download pdf (Page 12)

STARTING WARM ENGINE

1. Ensure that there is fuel and chain oil in the tanks.

2. Move chain brake lever (E) fully forward to lock chain brake

before starting.

3. Lay unit on a flat, clear area and keep bar and chain clear of all

obstacles.Hold top handle with one hand, and depress throttle

trigger lockout, but do not depress throttle trigger.

4. Move ignition/choke lever (A) forward to “Run” position ( I ).

5. Pull starter handle.

NOTE

If engine does not start after 5 pulls, use cold start procedure.

RUNNING

WARNING DANGER

The saw chain should not move at idle, otherwise serious personal

injury may result.

NOTE

If saw chain moves, adjust carburetor according to “Carburetor

Adjustment” instructions in this manual, or see your dealer.

• After engine starts, allow it to return to idle and warm up before

using.

• Move chain brake lever fully rearward to unlock chain brake.

• Press throttle control lockout then gradually squeeze throttle

trigger to increase engine speed.

• Saw chain starts moving when the engine reaches approximately

4200 rpm.

• Ensure proper acceleration and lubrication of chain and bar.

• Do not run the engine at high speed unnecessarily.

• Be sure that saw chain stops moving when throttle trigger is

released.

STOPPING

1. Release throttle trigger (D) and move lever (A) rearward to STOP

(O) position.

2. Move chain brake lever (E) fully forward to lock chain brake.

NOTE

If engine does not stop, move ignition/choke lever forward to

choke position ( ) to stop engine. Return the unit to your

authorized ECHO dealer to check and repair stop switch before

starting the engine again.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

McCulloch CS 360T Instruction Manual Page 12