McCulloch CS 360T Instruction Manual download pdf (Page 18)

SPARK PLUG

• Check periodically.

IMPORTANT

Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada)

otherwise severe engine damage may occur.

1. Remove air cleaner cover.

2. Remove spark plug lead and spark plug.

3. Gap = 0.65 mm (0.026 in)

4. Replace if electrode is worn, or if the insulator is fouled by oil

or other deposits

5. Torque = 150 – 170 kg/cm (130 – 150 in. lb.)

IMPORTANT

Do not over-torque

COOLING SYSTEM CLEANING

NOTE

See “Guide Bar and Saw Chain-Install/Remove Instructions for

sprocket guard removal/replacement instructions.

Muffler Side

1. Remove air filter cover and remove spark plug lead.

2. Remove two guide bar nuts and remove sprocket guard.

3. Remove three muffler cover screws and remove muffler cover.

4. Using a stiff bristle cleaning brush (do not use a metal brush),

remove debris from cylinder fins in muffler area.

5. Assemble components in reverse order

Starter Side

1. Remove air filter cover and remove spark plug lead.

2. Remove plastic plug in side handle mount (D), and remove

side handle mounting screw.

3. Remove four starter cover screws and remove starter cover.

4. Using a stiff bristle cleaning brush (do not use a metal brush),

remove debris from flywheel and ignition coil area.

5. Assemble components in reverse order.

SPROCKET

• A damaged sprocket (C) will cause premature damage or wear of

saw chain.

• Clean sprocket, clutch and bar mount area before installation of

bar.

• Check sprocket when you install new chain. When outer diameter

of sprocket is worn 0.5mm (.020”) or more, replace it.

IMPORTANT

Some tree sap and resins are corrosive. Thoroughly wash the guide

bar and sprocket areas after each use, then coat metal parts with

light oil.

Worn : 0.5 mm

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comments to this Manuals

No comments

McCulloch CS 360T Instruction Manual Page 18

Comments to this Manuals

Related products and manuals for Power chainsaws McCulloch CS 360T