McCulloch EB356 Service Manual download pdf (Page 30)

SOI/TD - PR 30 599 36 25-10

5.12.1 “Blending” function

This function is performed inside the fill tank during the water fill phase. Depending on the position

of the selector, softened water is automatically blended with the unsoftened water present in the appliance.

The softened water is introduced from the softening system into the sump, while the unsoftened water flows

through an open by-pass valve directly through the steam venting ring.

When the regeneration system is set to levels [1-4], it is advisable to activate the BLENDING

function to mix softened water with unsoftened water.

This function optimises the consumption of salt, thus preventing corrosion of glassware when the

water is very soft.

When the BLENDING function is activated, the percentage of

unsoftened water introduced into the dishwasher is 15%.

The BLENDING function is activated using the selector knob located

inside the tub, on the left side, in the vicinity of the steam venting grille:

Position of selector

 position 1 = blending enabled

 position 2 = blending disabled.

5.12.2 Table of regeneration values

Water fill between

regeneration

procedures

Time

regeneration

solenoid opens

Position of

tank

selector

Hardness of water

treated

Level Display

litres sec no. º F (TH) º D (dH)

1L - - - 0 1 0 > 8 0 > 4

2 L 130 240 1 9 > 14 5 > 8

3 L 94 240 1 15 > 20 9 > 11

4 L 70 240 1 21 > 30 12 > 17

* 5

5 L 53 240 2 31 > 40 18 > 22

6 L 37 240 2 41 > 50 23 > 28

7 L 20 240 2 51 > 60 29 > 33

8 L 15 240 2 61 > 70 34 > 39

9 L 10 240 2 71 > 80 40 > 45

10 L 3 2x240 2 81 > 90 46 > 50

* “5” = Level set at factory Position of tank selector: “2”

5.13 Drying

ACTIV-DRY TURBO-DRY

In these dishwashers, the dishes

are dried by a steam condensation

process. This drying system is

based on the natural circulation of

the hot air produced during the hot

rinse, when steam circulates inside

the condenser on the fill tank.

The condenser is a (cold wall)

condensation chamber filled with

water, against which the hot air is

ducted. This contact between the

hot air and the cold wall generates

a process of condensation.

The type of drying system can be

either “activ-dry” or “turbo-dry”,

depending on the model of

machine.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 46 47

Comments to this Manuals

No comments

McCulloch EB356 Service Manual Page 30

Comments to this Manuals

Related products and manuals for Power chainsaws McCulloch EB356